Distributor/Agen Resmi Boonton Indonesia - 4540 Peak Power Meter
RF Power Meters ,RF Power Sensors ,RF Volt Meters ,Modulation Analyzers ,Audio Analyzers ,Capacitance Meters ,PIM Testers
4540 Peak Power Meter
Boonton’s versatile 4541 (1 Ch) and 4542
(2 Ch) combined Peak / Average Power and Voltage meters are leading
edge instruments for most accurate RF measurements. Features like high
dynamic range, rise time of less than 7ns and an effective time
resolution of 200 ps provide the greatest detail in signal waveform
analysis. These meters are the instruments of choice for capturing,
displaying and analyzing RF power in both the time and statistical
domains. Applications include pulsed RF signals such as RADAR, MRI
particle accelerators, pseudorandom or noise-like signals such as CDMA,
WLAN and WiMAX, LTE, UMTS. The high dynamic range and very fast sampling
rate make the 4540 series also ideal to measure RF telecommunication
amplifiers. Both Boonton 4541 and 4542 Power meters, have built in step
calibrators for highest accuracy allowing calibrating sensors over their
full range right before the measurement. A wide range of power sensors
and voltage probes is available for these instruments.
Quick Specifications
| Sensor Inputs | |
|---|---|
| RF Channels | 1 or 2 |
| RF Frequency Range | 9.9 kHz to 110 GHz* |
| Peak Pwr range | -50 to +20 dBm* |
| CW Pwr range | -70 to +44 dBm* |
| Acquisition and Measurement System | |
| Time resolution | 0.2 ns |
| A/D Converter | 14 bit |
| DSP | 32 bit floating point |
| Trigger | |
| Ext Trig range, impedance | ±5V, 1 Mohm |
| Min trig pulse width | 15 ns |
| Max trig rate | 30 MHz |
| Calibrator Source | |
| Internal Calibrator | 50.025 MHz, CW -60 to +20 dBm |
| * Sensor Dependent, Calibrator Dependent | |
| Pulse Mode Operation (Automatic) | |
| Pulse width | Pulse rise-time |
| Pulse fall-time | Pulse period |
| Pulse repetition frequency | Pulse duty cycle |
| Pulse off-time | Peak power |
| Pulse “on” power | Pulse overshoot (dB or %) |
| Waveform Average power | Top level power (IEEE spec) |
| Bottom level power (IEEE spec) | Edge delay |
| Edge skew (2 channel instruments only) | |
| Marker Measurements | |
| Markers (vertical cursors) Settable in time relative to the trigger position |
|
| Markers independently Average, minimum, peak power at a single time offset |
|
| Pair of Markers Average, minimum, peak power over the interval between markers, power ratio between markers | |
Post a Comment